Dell Inspiron 6400 E1505 Service Manual pocitarna cz

Dell Inspiron 6400 E1505 Service Manual Pocitarna Cz-PDF Download

  • Date:15 Jun 2020
  • Views:12
  • Downloads:0
  • Pages:45
  • Size:1.63 MB

Share Pdf : Dell Inspiron 6400 E1505 Service Manual Pocitarna Cz

Download and Preview : Dell Inspiron 6400 E1505 Service Manual Pocitarna Cz


Report CopyRight/DMCA Form For : Dell Inspiron 6400 E1505 Service Manual Pocitarna Cz


Transcription:

Back to Contents Page,Battery Latch Assembly,Dell Inspiron 6400 E1505 Service Manual. Removing the Battery Latch Assembly,Replacing the Battery Latch Assembly. Removing the Battery Latch Assembly, CAUTION Before you begin the following procedure follow the safety instructions in the Product Information Guide. NOTICE To avoid electrostatic discharge ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface such. as the back panel on the computer, NOTICE To help prevent damage to the system board remove the main battery see Before Working Inside Your Computer before working inside the. 1 Follow the instructions in Before Working Inside Your Computer. 2 Remove the hard drive see Removing the Hard Drive. 3 Remove the hinge cover see Removing the Hinge Cover. 4 Remove the keyboard see Keyboard, 5 Remove the display assembly see Removing the Display Assembly.
6 Remove the palm rest see Removing the Palm Rest, 7 Remove the video card thermal cooling assembly if present see Removing the Video Card Thermal Cooling Assembly. 8 Remove the processor thermal cooling assembly see Removing the Processor Thermal Cooling Assembly. 9 Remove the system board see Removing the System Board. 10 Remove the M2 x 2 7 mm screw from the battery latch assembly. When you remove the M2 x 2 7 mm screw the battery latch release on the bottom of the computer will also be removed. 1 M2 x 2 7 mm screw 2 battery latch assembly, 11 Remove the spring from the hook on the computer base by lifting it away with a screwdriver or a plastic scribe. 1 hook 2 spring, 12 Remove the plastic battery latch assembly by twisting the assembly slightly and lifting it out of the channel and away from the computer base. 1 battery latch assembly,Replacing the Battery Latch Assembly. 1 Insert the latch assembly into the channel on the computer base and press it into place. 2 Using a small screwdriver hook the spring over the hook on the computer base. 3 Place the battery latch release under the computer base line it up with the hole in the base and then replace the screw in the assembly. Ensure that the newly installed latch moves smoothly and freely when pushed and released. 4 Replace the hard drive bay and reinsert the two M3 x 3 mm screws. 5 Replace the system board and the three M2 5 x 5 mm screws. 6 Replace in reverse order the other components that you removed in Removing the Battery Latch Assembly. Back to Contents Page,Back to Contents Page,Before You Begin.
Dell Inspiron 6400 E1505 Service Manual,Recommended Tools. Turning Off Your Computer,Before Working Inside Your Computer. Computer Orientation,Screw Identification, This section provides procedures for removing and installing the components in your computer Unless otherwise noted each procedure assumes that the. following conditions exist, l You have performed the steps in Turning Off Your Computer and Before Working Inside Your Computer. l You have read the safety information in the Dell Product Information Guide. l A component can be replaced or if purchased separately installed by performing the removal procedure in reverse order. Recommended Tools, The procedures in this document may require the following tools.
l Small flat blade screwdriver,l Phillips screwdriver. l Small plastic scribe,l Flash BIOS update program CD. Turning Off Your Computer, NOTICE To avoid losing data save and close any open files and exit any open programs before you turn off your computer. 1 Shut down the operating system, Save and close any open files exit any open programs click Start Shut Down Shut down. The computer turns off after the operating system shutdown process finishes. 2 Ensure that the computer and any attached devices are turned off If your computer and attached devices did not automatically turn off when you shut. down your operating system press and hold the power button for 4 seconds. Before Working Inside Your Computer, Use the following safety guidelines to help protect your computer from potential damage and to help ensure your own personal safety.
CAUTION Before you begin any of the procedures in this section follow the safety instructions in the Product Information Guide. NOTICE Handle components and cards with care Do not touch the components or contacts on a card Hold a card by its edges or by its metal. mounting bracket Hold a component such as a processor by its edges not by its pins. NOTICE Only a certified service technician should perform repairs on your computer Damage due to servicing that is not authorized by Dell is not. covered by your warranty, NOTICE When you disconnect a cable pull on its connector or on its pull tab not on the cable itself Some cables have a connector with locking tabs if. you are disconnecting this type of cable press in on the locking tabs before you disconnect the cable As you pull connectors apart keep them evenly. aligned to avoid bending any connector pins Also before you connect a cable ensure that both connectors are correctly oriented and aligned. NOTICE To help prevent damage to the computer perform the following steps before you begin working inside the computer. 1 Ensure that the work surface is flat and clean to prevent the computer cover from being scratched. 2 Turn off your computer see Turning Off Your Computer. NOTICE To disconnect a network cable first unplug the cable from your computer and then unplug it from the network device. 3 Disconnect any telephone or network cables from the computer. 4 Disconnect your computer and all attached devices from their electrical outlets. 5 Close the display and turn the computer upside down on a flat work surface. NOTICE To help prevent damage to the system board remove the main battery before working inside the computer. 6 Remove the main battery, a Slide the battery bay latch release on the bottom of the computer. b Remove the battery from the battery bay,1 battery bay latch release 2 main battery. 7 Turn the computer top side up,Computer Orientation. 1 front 2 left 3 back,Screw Identification, When you are removing and replacing components print the screw identification chart as a tool to lay out and keep track of the screws The chart provides the.
number of screws and their sizes,Optical Drive Hard Drive Modem. 1 each 2 each 1 each,Display Assembly bottom and,Keyboard Display Assembly top. 2 each 2 each,Display Bezel,Display Panel Palm Rest. 6 each under rubber display,8 each 11 each bottom side. Speakers Fan System Board,4 total 2 per speaker 4 total 2 per fan 3 each.
Hard Drive Bay Battery Latch,2 each 1 each,Back to Contents Page. Back to Contents Page,Internal Card With Bluetooth Wireless Technology. Dell Inspiron 6400 E1505 Service Manual,Removing the Card. Replacing the Card,Removing the Card, CAUTION Before you perform the following procedures follow the safety instructions in the Product Information Guide. NOTICE To avoid electrostatic discharge ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface such. as the back panel on the computer, NOTICE To avoid damaging the system board you must remove the main battery see Before Working Inside Your Computer before you begin.
working inside the computer, NOTE If you ordered an internal card with Bluetooth wireless technology with your computer the card is already installed. 1 Follow the instructions in Before You Begin, NOTE Ensure that you have removed the main battery for access to the card. 2 Use a plastic scribe to pry the card door open, 3 Disconnect the card cable connector from the card and remove the door with the card from the computer. 4 Slide the card out of the plastic brackets, 1 card door 2 card cable 3 internal card with Bluetooth wireless. connector technology,4 plastic brackets,Replacing the Card.
1 To replace the card connect the card to the cable then insert it into the compartment. 2 Replace the card door by inserting the small center tab into the notch at the base of the compartment and snap it into place. 3 Replace the battery,Back to Contents Page,Back to Contents Page. ExpressCard Hard Drive Bay Assembly,Dell Inspiron 6400 E1505 Service Manual. CAUTION Before you begin the following procedure follow the safety instructions in the Product Information Guide. NOTICE To avoid electrostatic discharge ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface such. as the back panel on the computer, NOTICE To help prevent damage to the system board remove the main battery see Before Working Inside Your Computer before working inside the. NOTE You can remove the hard drive bay without removing the ExpressCard cage The only reason for removing the ExpressCard Cage from the hard. drive bay is if you are replacing an existing ExpressCard cage or hard drive bay. 1 Follow the instructions in Before Working Inside Your Computer. 2 Remove the hard drive see Removing the Hard Drive. 3 Remove the optical drive see Optical Drive, 4 Remove the hinge cover see Removing the Hinge Cover. 5 Remove the keyboard see Keyboard, 6 Remove the display assembly see Removing the Display Assembly.
7 Remove the palm rest see Removing the Palm Rest, 8 If applicable remove the video card thermal cooling assembly see Video Card Thermal Cooling Assembly otherwise continue to step 9. 9 Remove the six M2 5x 5 mm screws from the ExpressCard hard drive bay assembly. 1 M2 5 x 5 mm screws 6 2 ExpressCard hard drive bay assembly. 10 Remove the assembly from the system board,Back to Contents Page. Back to Contents Page,Dell Inspiron 6400 E1505 Service Manual. If you ordered a Mini Card with your computer the card is already installed. CAUTION Before you begin any of the procedures in this section follow the safety instructions in the Product Information Guide. NOTICE To help prevent damage to the system board you must remove the battery from the battery bay before you begin working inside the. 1 Follow the procedures in Before You Begin,2 Remove the hinge cover See Hinge Cover. 3 Remove the keyboard See Keyboard, 4 If a Mini Card is not already installed go to step 5 If you are replacing a Mini Card remove the existing card.
a Disconnect the two antenna cables from the Mini Card. 1 Mini Card 2 antenna cables 2 3 antenna cable connectors 2. b Release the Mini Card by pushing the metal securing tabs toward the back of the computer until the card pops up slightly. c Lift the Mini Card out of its system board connector. 1 system board connector 2 Mini Card 3 metal securing tabs 2. NOTICE The connectors are keyed to ensure correct insertion If you feel resistance check the connectors on the card and on the system board and. realign the card,5 Install the replacement Mini Card. a Insert the Mini Card connector into the system board connector at a 45 degree angle and then press the other end of the Mini Card down into. the securing tabs until the card clicks into place. NOTICE To avoid damage to the Mini Card never place cables under the card. b Connect the two antenna cables to the Mini Card black cable to the connector labeled AUX and the white cable to the connector labeled. 1 system board connector 2 antenna cables 2 3 antenna cable connectors 2. Back to Contents Page,Back to Contents Page,Coin Cell Battery. Dell Inspiron 6400 E1505 Service Manual,Removing the Coin Cell Battery. Replacing the Coin Cell Battery,Removing the Coin Cell Battery. CAUTION Before you begin the following procedure follow the safety instructions in the Product Information Guide. NOTICE To avoid electrostatic discharge ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface such. as the back panel on the computer, NOTICE To help prevent damage to the system board remove the main battery see Before Working Inside Your Computer before working inside the.
1 Follow the instructions in Before Working Inside Your Computer. 2 Remove the hinge cover see Removing the Hinge Cover. 3 Remove the keyboard see Keyboard, 4 Insert a plastic scribe into the guide on the side of the coin cell battery compartment and pry out the battery. Replacing the Coin Cell Battery, 1 When you replace the battery insert it at a 30 degree angle under the clip with the positive identified by a plus symbol side up and then push it. into place,2 Replace the keyboard see Keyboard, 3 Replace the hinge cover see Replacing the Hinge Cover. Back to Contents Page,Back to Contents Page,System Components. Dell Inspiron 6400 E1505 Service Manual, NOTICE Only a certified service technician should perform repairs on your computer Damage due to servicing that is not authorized by Dell is not.
covered by your warranty, NOTICE Unless otherwise noted each procedure in this document assumes that a part can be replaced by performing the removal procedure in. reverse order,1 display assembly 2 hinge cover 3 keyboard. 4 palm rest with 5 computer base 6 hard drive, 7 processor 8 system board 9 ExpressCard Hard Drive Bay. 10 main battery 11 video card thermal cooling 12 processor thermal cooling. assembly assembly,13 speakers 2 14 fan 15 optical drive. Back to Contents Page,Back to Contents Page,Processor Module.
Dell Inspiron 6400 E1505 Service Manual,Removing the Processor Module. Replacing the Processor Module,Removing the Processo. registered trademark owned by Bluetooth SIG Inc and is used by Dell under license Other trademarks and trade names may be used in this document to refer to either the entities claiming the marks and names or their products Dell Inc disclaims any proprietary interest in trademarks and trade names other than its own Model PP20L

Related Books